Plumbing online store

050-840-67-47    096-384-67-81


Corner 20x20 metal-plastic

  • Corner 20x20 metal-plastic


from 1 pc.1 95.22 грн.
from 10 pc.1 81.97 грн.

Square material Brass, Nickel-chromium plating, Nominal bore 20 mm, Working medium Non-aggressive medium, Water, Air, Gas, Liquid medium, Oil, Working pressure 16 bar, Maximum working medium temperature 90 degrees. Bending angle 90 degrees Coupling type Connecting

Corner 20x20 metal-plastic

A crimping angle for metal-plastic is used to connect two metal-plastic pipes or pipes and some kind of plumbing fitting to each other at an angle of 90˚. This type of connecting elbows is suitable for installation where the pipes or fittings to be connected can have different diameters.The installation of the square is carried out by the crimp method, using a strong union nut. It is she who regulates the strength of the connection and is responsible for the tightness. Brass connecting elbow for metal-plastic is intended for use in hot and cold heating and water supply systems.Nickel-plated elbows provide stable protection against corrosion and significantly extend their service life.

Compression fittings allow, without the use of welding equipment and other special devices, to easily and quickly connect metal-plastic pipes together into a single communication system.To fix them in this situation, a crimp method is used, and a regular wrench is used as a tool. Among the advantages that metal-plastic fittings have, first of all, the extreme ease of installation is noted.Another important characteristic is that clamping fittings are collapsible components. In practice, this means that if the need arises, you can quickly dismantle and reassemble the connection and change its original configuration.Fittings can be installed at any, even low ambient temperatures. Compression fittings can be used when installing pipes for drinking, industrial cold water supply, heating systems and in underfloor heating systems.... They must be protected from the harsh chemical environment. The disadvantage of using this type of fittings is the low tightness of the joints at medium and high levels of working pressure.

Buy product Corner 20x20 metal-plastic in our online store

Write a review

Note: HTML is not translated!
    Bad           Good